|
 |
Сегодня день рождения отмечает Атарик!
Ниссан 4х4 Клуб поздравляет именинника! |
|
|
|
| NISSAN 4x4 | |
| Автор: George |
Написан: 12-12-2009 |
| Тема: видимо всё-таки ECM-10. вот что по этому поводу сказано в мануале: |
Description
The ECM consists of a microcomputer and connectors for signal
input and output and for power supply. The unit controls the
engine.
On Board Diagnosis Logic
Malfunction is detected when ... Check Items (Possible Cause)
+ An excessively high or low voltage from the absolute pressure
sensor (built-into ECM) is sent to ECM.
+ ECM
(ECCS-D control module)
DTC Confirmation Procedure
WITH CONSULT-II
1) Turn ignition switch “ON”.
2) Select “DATA MONITOR” mode with CONSULT-II.
3) Start engine and wait at least 2 seconds.
4) If DTC is detected, go to “Diagnostic Procedure”, EC-1188.
WITHOUT CONSULT-II
1) Turn ignition switch “ON” and wait at least 2 seconds.
2) Start engine and wait at least 2 seconds.
3) Turn ignition switch “OFF”, wait at least 5 seconds and then
turn “ON”.
4) Perform “Diagnostic Test Mode II (Self-diagnostic results)”
with ECM.
5) If DTC is detected, go to “Diagnostic Procedure”, EC-1188.
SEC220B
SEF817Y
DTC 0802 ECM 10 ZD30DDTi
EC-1187
Diagnostic Procedure
1 INSPECTION START
With CONSULT-II
1. Turn ignition switch “ON”.
2. Select “SELF DIAG RESULTS” mode with CONSULT-II.
3. Touch “ERASE”.
4. Perform “DTC Confirmation Procedure”, EC-1187, again.
5. Is the malfunction displayed again?
Without CONSULT-II
1. Turn ignition switch “ON”.
2. Erase the Diagnostic Test Mode II (Self-diagnostic results) memory.
3. Perform “DTC Confirmation Procedure”, EC-1187, again.
4. Perform “Diagnostic Test Mode II (Self-diagnostic results)”.
5. Is the DTC 0802 displayed again?
Yes or No
Yes c Replace ECM.
No c INSPECTION END
DTC 0802 ECM 10 ZD30DDTi
EC-1188
|
| Ответить
· Ответить с цитатой |
Ответы и комментарии:
-
нужна информация - stasimo, москва, 16:44, 11-12-2009
|
|
|
